Filter
Top Products
Appendix A Screen Details
> A.6 Advanced Copy Status
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
690
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
• SDP Used Block
[-] (hyphen) is displayed.
However, when the [Status] is [Reserve], the field is blank.
• Resolution
The bitmap ratio of the session (x1/x2/x4/x8/x16) (*1) is displayed.
However, when the [Status] is [Reserve], the field is blank.
When the Volume Type is [Mainframe], [-] (hyphen) is displayed.
*1: Bitmap ratio can be changed during the copy session. The changed bitmap ratio will be applied
from the next session. The session executes using the bitmap ratio from the start until copying is
complete.
A.6.2 Advanced Copy Status (OPC Session List) Screen
This screen displays the status of OPC sessions.
When Resource Domains are registered in the ETERNUS DX400/DX8000 series, the displayed
OPC sessions differ depending on the current user account.
When logged on using a Total Administrator account, all the active OPC sessions are displayed.
When logged on using a Resource Domain Administrator account, the active OPC sessions in
the ETERNUS DX400/DX8000 series in which the copy source or copy destination volume is
registered in the relevant Resource Domain, Shared Resource, or volumes that cannot be
assigned to Resource Domains, are displayed.
When Resource Domains are not registered, all the active OPC sessions are displayed.
■ OPC Session List
● Displayed contents
• SID
The session ID is displayed in 0x0000 – 0xFFFF (hexadecimal).
Clicking the [SID] link displays the [OPC Session Details] screen. However, when [Reserve] is
displayed for [Status], a link is not displayed.
• Type
The type of the session is displayed.
- OPC: OPC session
- QOPC: QuickOPC session
- SOPC: SnapOPC session
- SOPC+: SnapOPC+ session
- MON: Monitoring session (*1)
*1: The Monitoring session is a pseudo SnapOPC or SnapOPC+ session, which is used to
estimate the updated data size. Check the updated data size of the copy source before
performing a SnapOPC or SnapOPC+ session from the [Completed Block]. Since the
Monitoring session only exists on the copy source and not on the copy destination, a hyphen [-
] is displayed in the [To Vol.] field.