Filter
Top Products
Appendix A Screen Details
> A.34 Set IP Address for REMCS Port
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
798
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
A.34 Set IP Address for REMCS Port
A.34.1 Set IP Address for REMCS Port (Initial) Screen
On this screen, the IP Address, the Subnet Mask, etc. of the REMCS port currently registered in
the device are displayed. To change the network environmental settings of the REMCS port, set
each parameter in the text box. The network environmental settings of the REMCS port can also
be deleted on this screen.
● Setting item
• Network Settings
- IP Address
Set the IP Address of the REMCS port in numerals 0 – 255.
The initial status is blank.
- Subnet Mask
Set the Subnet Mask of the REMCS port in numerals 0 – 255.
The initial status is blank.
- Gateway
Set the gateway IP Address of the REMCS port in numerals 0 – 255.
When you access the device from outside the subnet, this setting is required.
The initial status is blank.
- Allow same subnet access
Selects "Yes" or "No" for access to the REMCS port from the same subnet with the radio
button.
The default setting is "No".
• DNS Settings
- DNS Settings
Set the IP Addresses for the Primary DNS and Secondary DNS in the REMCS port in
numerals 0 – 255.
The initial status is blank.
• IP Access Settings
- IP Access Settings
Set the subnet or network address (or IP Address) of the device, that is used for
communication from out of the subnet to the REMCS port in numerals 0 – 255.
Up to 15 IP Access Settings can be set. The initial status is blank.
• Network Address
• Subnet Mask