Filter
Top Products
Chapter 6 Settings Menu
> 6.4 SNMP
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
504
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
6.4.3 SNMP Trap Test
The trap is transmitted from the SNMP Agent to the SNMP Manager on this screen to test com-
munication between the SNMP Agent installed in the device and the SNMP Manager.
When device management is executed by using SNMP, after configuring SNMP Agent and
SNMP Manager, it is necessary to confirm that the communication is possible. Therefore, trans
-
mit trap from the SNMP Agents to the SNMP Manager, and confirm communication on both
sides of the SNMP Agent and SNMP Manager.
The following explains the execution procedures for [SNMP Trap Test].
Procedure
1 Click [SNMP Trap Test] under the SNMP in the [Settings] menu.
→ The [SNMP Trap Test (Initial)] screen appears.
2 Click the [Execute] button to execute SNMP Trap Test.
→ The [SNMP Trap Test (Result)] screen appears.
3 Click the [OK] button.
■ When the SNMP function is enabled:
→ Returns to the [Menu] screen.
• [SNMP Trap Test] is a function that transmits traps from the SNMP
Agent to the SNMP Manager. If the SNMP function is enabled, after
transmitting a trap confirm that it was received on the SNMP Manager
side.
• If a trap is transmitted, but the SNMP function is disabled, a message
indicates that the function is not available.