Filter
Top Products
Appendix A Screen Details
> A.18 Set CA Parameters
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
746
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
- FC-AL Connection
Multiple nodes are connected on the Loop.
• Loop-ID (Manual/Auto)
Decide how to assign a Loop-ID for the RFCF-RA Port using the radio buttons. Loop-ID is a
node identification number in the Loop.
- Loop-ID (Manual)
Any Loop-ID (0x00 – 0x7D) can be assigned.
- Loop-ID (Auto)
Loop-ID is assigned automatically in the Loop.
• Loop-ID
- Select a Loop-ID (0x00 – 0x7D) for the RFCF-RA Port from the list box.
- Select a Loop-ID setting order (Descending/Ascending) for the RFCF-RA Port from the list
box.
• Transfer Rate
Select a Transfer Rate for the RFCF-RA Port from the list box.
- 4G/2G/1Gbit/s Auto: Selects the transfer rate automatically. (Default)
- 4Gbit/s: Sets the transfer rate to 4Gbit/s.
- 2Gbit/s: Sets the transfer rate to 2Gbit/s.
- 1Gbit/s: Sets the transfer rate to 1Gbit/s.
Be sure to specify [Fabric connection] for the Connection Topology.
The RFCF-RA port does not support the [FC-AL connection].
This setting is enabled only when the [FC-AL Connection] is selected
for the Connection Topology.
• This setting is enabled only when the [FC-AL Connection] and
[Loop-ID (Manual)] is selected for the Connection Topology.
• Do not select the same Loop-ID as any other ports including the
host adapters connected to the ETERNUS8000 in Loop-ID.
This setting is enabled only when the Connection Topology is [FC-AL
Connection] and also the [Loop-ID (Auto)] is selected.
Current transfer rate setting can be checked in the "Link Status" column
on the CA details screen (FC) under the [Device Status] menu.