Chapter 6 Settings Menu
> 6.8 Others
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
598
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
4 Click the [Close] button.
→ The window is closed.
End of procedure
6.8.2 Set IP Address for REMCS Port
This function performs the network environment settings with which the E T E R N U S D X 4 0 0 /
DX8000 series
communicates with an external device using the REMCS Port IP address.
REMCS port is a LAN port different from the USER port usually used. This LAN port is used for
remote maintenance only.
The following explains the setting procedures for [Set IP Address for REMCS Port].
The following settings are available for [Set IP Address for REMCS Port].
• Set IP Address for REMCS Port
• Delete REMCS Port Settings
These procedures are explained in the following sections.
• When the device is set to communicate with ETERNUSmgr via
the USER Port, this communication will be interrupted if the
USER Port IP Address or Subnet Mask is deleted. Please contact
a maintenance engineer and have the USER Port registered and
setup again from FST.
• It is necessary to logon again, after setting is completed.
Execute from the [Set IP Address for USER Port] function for setting and
updating the USER port (main LAN port) of ETERNUS DX400/DX8000
series.