Filter
Top Products
Appendix C Syslog Message List
> C.2 Syslog Message List
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
833
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
M E005nxxx WRITE BAD DATA
Writing of Bad Data (data lost identifier) occurs.
M E10300mm PINNED DATA
Pinned data occurs.
M E2070001 NOT READY(01:Configuration Error)
The device is in Not Ready status.
Shipment settings (model setting) and configuration settings are not
performed.
M E2070002 NOT READY(02:CM F/W Version Error)
The device is in Not Ready status.
Firmware version for the CM is not correct.
M E2070004 NOT READY(04:Restore Fail)
The device is in Not Ready status.
Backup is successfully complete, but cannot perform the restoration.
M E207000B NOT READY(11:Power Off/Fail Incomplete)
The device is in Not Ready status.
Failed to power off. Or the device power powers off immediately after the
device powers on.
M E207000C NOT READY(12:Backup Fail)
The device is in Not Ready status.
Backup failed.
M E207000D NOT READY(13:Multi CM Down)
The device is in Not Ready status.
Adjoining CMs with LUs are degraded.
M E207000E NOT READY(14:Machine Down Recovery End)
The device is in Not Ready status.
Machine down recovery is performed.
M E207000F NOT READY(15:Machine Down Recovery Failed)
The device is in Not Ready status.
Failed to perform machine down recovery.
M E2070010 NOT READY(16:DE Build Error)
The device is in Not Ready status.
Failed to configure DE because of DEI cable errors or FC cable errors.
M E2070011 NOT READY(17:CM Memory Shortage)
The device is in Not Ready status.
Memory capacities are smaller than the minimum value in multiple CMs.
M E2070013 NOT READY(19:FRT Fault)
The device is in Not Ready status.
FRT is failed.
M E2070014 NOT READY(20:BRT Fault)
The device is in Not Ready status.
BRT is failed.
M E406C0kk FC Loop Recovery Completed
FC-Loop recovery is complete.
Event type code Upper: Message
Lower: Description