Filter
Top Products
Appendix A Screen Details
> A.36 Set Remote Support
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
806
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
• REMCS Center
- REMCS Center (Required)
Select the REMCS center to be connected to the device from the list box.
• Blank (default setting)
• Fujitsu America
• Australia
• Brazil
• Hong-Kong
• China
• Indonesia
• Korea
• Malaysia
• Philippine
• Singapore
• Taiwan
• Thailand
• Vietnam
• Individual support in Hawaii
• OSC
■ Detailed Settings Information
• E-Mail sent in split mode Setting
Select whether over-size E-Mails are to be split when the ETERNUS DX400/DX8000 series
sends information to the REMCS center.
E-Mails that exceed the specified size (from the default 64KB, up to 6400KB) are to be split
up, then sent. If the customer's mail server does not permit the sending of split E-Mails, select
[E-Mail sent in NON split mode].
- E-Mail sent in split mode (default setting)
If the E-Mail exceeds the specified capacity (from the default 64KB, up to 6400KB), split
the E-Mail and send.
- E-Mail sent in NON split mode
Send the E-Mail without splitting it.
• Set the device name for HELO/EHLO command
When sending "HELO" or "EHLO" command from the ETERNUS DX400/DX8000 series to
the mail server, use the radio button to select
"None Specified" (default setting) or "Specifying"
the device name as the domain.
If "Inputting directly" is displayed, the center cannot be changed to
another location.
Mail protocol requires that a domain name be specified for the "HELO"
or "EHLO" command. If [None Specified] is selected, the ETERNUS
DX400/DX8000 series sends the part of the Sender E-Mail address after
the "@" mark. If the customer's mail server may not be used for the
domain, select [Specifying] and input an appropriate domain.