Filter
Top Products
Appendix A Screen Details
> A.18 Set CA Parameters
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
750
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
- Alias name
Set the Alias Name for the iSCSI-CA Port (can be omitted).
Alphanumeric characters and 1 -31 characters can be used.
Alias name is a nickname of the iSCSI Name that identifies the iSCSI-CA Port. Since the
iSCSI name is a very long identifier (up to 223 characters), the Alias name is used in
substitution for the iSCSI name.
• Transfer Rate
- Transfer Rate
Set the transfer rate of the iSCSI-CA Port.
• 1Gbit/s: Sets the transfer rate to 1Gbit/s (full-duplex).
• CHAP
- CHAP
Select ON (Enabled) or OFF (Disabled) for CHAP of the iSCSI-CA Port.
• ON: CHAP is enabled.
• OFF: CHAP is disabled. (Default)
CHAP (Challenge Handshake Authentication Protocol) is one of the authentication
protocols. In CHAP, the ETERNUS DX400/DX8000 series sends the host an encrypted
password which is based on a random key received from the host and the host decides
whether to connect or not. Since iSCSI uses an IP network that is used by the general
public, the security measures described above are required.
- Current Password
Enter the current password to be used for the CHAP of the iSCSI-CA Port (can be omit-
ted).
From 12 to 100 alphanumeric characters (ASCII codes: 0x20 to 0x7E) must be entered.
- User Name
Enter the user name to be used for the CHAP of the iSCSI-CA Port (can be omitted).
From 1 to 255 alphanumeric characters (ASCII codes: 0x20 to 0x7E) can be used.
- New Password
Enter a new password when the current CHAP password for the iSCSI-CA Port is to be
replaced.
From 12 to 100 alphanumeric characters (ASCII codes: 0x20 to 0x7E) must be entered.
- New Password (Re-enter)
Re-enter the new password to check that it has been entered correctly.
From 12 to 100 alphanumeric characters (ASCII codes: 0x20 to 0x7E) must be entered.
When the [Affinity Mode] is [OFF (Disabled)], CHAP cannot be [ON
(Enabled)].
• This is enabled only when "ON" is selected for CHAP.
• When setting the Password, check the "Change" checkbox.
• Make sure to set the user name and the password in pairs.
• This is enabled only when "ON" is selected for CHAP.
• When setting the User Name, check the "Change" checkbox.
• Make sure to set the user name and the password in pairs.