Filter
Top Products
Chapter 7 Download Menu
> 7.1 Download
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
617
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
7.1.3.1 Enabling the Syslog function
This section describes how to enable the Syslog function.
Procedure
1 Click [Set Syslog] in the [Download] menu.
→ The [Set Syslog (Initial)] screen appears.
Refer to "A.35.1 Set Syslog (Initial) Screen" (page 800) for screen details.
2 Set the following items and click the [Set] button.
• Syslog Function
Enable the Syslog function
• Common Settings
Set the "Use LAN Port" and "Output Log Type"
• Syslog Server 1 (required)
Specify the information of Syslog Server 1 that sends the Syslogs.
• Syslog Server 2 (can be omitted)
Specify the information of Syslog Server 2 that sends the Syslogs.
→ The [Set Syslog (Check)] screen appears.
• This function does not confirm whether the IP Addresses
specified for the "IP Address" fields of the Syslog Server 1 and
Syslog Server 2 are correct. When using the Syslog function,
make sure to confirm that the correct IP Address is specified.
• If the [Set] button is clicked in the following conditions, an error
screen appears.
- Characters other than numerals are specified in the "IP
Address" and/or "Port No." fields
- All the setting items for the IP Address are something other
than 0Byte (not specified) or 4Bytes (specified)
- Either the IP Address or the Port No. has been set
- Syslog Server 1 is not specified