Fujitsu DX400 Computer Drive User Manual


 
Appendix C Syslog Message List
> C.2 Syslog Message List
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
835
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
C.2.4 Informational Messages
This section describes the messages that are sent when the severity is Information.
Meaning of symbols
The following symbols are used in the Informational Message List. These symbols are described
in italics.
Symbol Meaning
a Number of Affinity Groups
aaaa Type of registration target license (Advanced Copy, Thin Provisioning, GS)
b Number of sessions
cccc Component name (CA, Disk, CM, DE, PBC, etc)
ccccc Setting contents (Configuration, Customer, Communication, Server Device,
Firmware, Log)
cccccc Reliability of TPP (High, Middle, None)
d Number of disks
dddd Component name (Memory, CA, Disk, CM, DE, etc)
eee Action when an error occurs (Any: Perform internal authentication when an
error occurs. Network: Perform internal authentication when a Network error
occurs. None: Do not perform internal authentication.)
eeeee Eco-mode settings (Start, Stop)
ffff Encryption mode (Fujitsu, AES)
GG DE-ID (hexadecimal)
ggggg Setting contents (Domains, Numerical Resources, RAID Group, Thin
Provisioning Pool, Host WorldWideName, iSCSI Host, Affinity Group, Host
Response, Eco-mode Schedule)
h Number of hosts
hhhh Type of hosts (FC, iSCSI)
kkkkk Enable/Disable of Syslog (Enable, Disable)
m Number of LUN Mappings
mm Slot number (hexadecimal)
mmmm Configuration application mode (Initialize, Restore)
n Number of RAID Groups
nnnnn Factor (Normal, Failure)
p Number of ports
ppp TPP number
rrrr Processing contents (Delete, Destage)
rrrrr Setting contents (Resume, Suspend, Maintenance)
s Numer of HS
ssss SID number (hexadecimal)
sssss Setting contents (Start, Stop)
t Number of TPPs
tttt Setting contents (Register, Delete)