Fujitsu DX400 Computer Drive User Manual


 
Appendix A Screen Details
> A.18 Set CA Parameters
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
755
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
- User Name
Enter the user name to be used for the CHAP of the iSCSI-RA Port (can be omitted).
From 1 to 63 alphanumeric characters (ASCII codes: 0x20 to 0x7E) can be used.
- New Password
Enter a new password when the current CHAP password for the iSCSI-RA Port is to be
replaced.
From 12 to 32 alphanumeric characters (ASCII codes: 0x20 to 0x7E) must be entered.
- New Password (Re-enter)
Re-enter the new password to check that it has been entered correctly.
From 12 to 32 alphanumeric characters (ASCII codes: 0x20 to 0x7E) must be entered.
Header Digest
Set Header Digest for the iSCSI-RA Port.
[Header Digest] is a check code which adds detailed information to the header division of
iSCSI-RA. Specify "CRC32C" when add check code from the host is requested.
- OFF (Default)
Does not add the check code.
- CRC32C
Adds the check code.
"CRC32C" is an algorithm when creating a check code.
Data Digest
Set Data Digest for the iSCSI-RA Port.
[Data Digest] is a check code which adds detailed information to the data division of iSCSI-
RA. Specify "CRC32C" when add check code from the host is requested.
- OFF (Default)
Does not add the check code.
- CRC32C
Adds the check code.
"CRC32C" is an algorithm when creating a check code.
This is enabled only when "ON" is selected for CHAP.
When setting the User Name, check the "Change" checkbox.
Make sure to set the user name and the password in pairs.