Filter
Top Products
Appendix A Screen Details
> A.6 Advanced Copy Status
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
696
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
• Status
The status of the session is displayed.
- Reserve: Session ID is reserved.
- Active: Operating normally
- Error: Interruption due to error
- Suspend: Interruption by command from the host
- Halt: The remote copy process cannot be performed, because of failure.
• Error Code
The error code (0x00 – 0xFF) of the session is displayed in hexadecimal number.
However, when the [Status] is [Reserve], the field is blank.
• Phase
Operation status of the session is displayed.
However, when the [Status] is [Reserve], the field is blank. In other cases, it is shown as
follows.
- No Pair: Duplicated pair of REC copy source and REC copy destination is not yet set up.
- Copying: REC copy is in progress
- Equivalent: After completing the copy processing, REC copy source and REC copy
destination are duplicated, and equivalent status is maintained.
• Time sec.
The elapsed time from starting the session is displayed. (unit: seconds)
However, when the [Status] is [Reserve], the field is blank.
• Volume Type
The type of the volume to be copied in the session (Open, Mainframe) is displayed.
However, when the [Status] is [Reserve], the field is blank.
• Role
In the relevant copy session, the role of this device is displayed.
However, when the [Status] is [Reserve], the field is blank. In other cases, it is shown as
follows.
- P: Primary (Copy source)
- S: Secondary (Copy destination)
• From Vol.
The Logical Volume number of the copy source in the session is displayed in 0x0000 –
0x3FFF (hexadecimal).
However, when the [Status] is [Reserve], the field is blank.
• To Vol.
The Logical Volume number of the copy destination in the session is displayed in 0x0000 –
0x3FFF (hexadecimal).
However, when the [Status] is [Reserve], the field is blank.
• Total Block
The total number of data blocks that are to be copied for each session is displayed in decimal.
Units for each volume type are as follows:
- Open Volume: Block
- Mainframe Volume: Track
However, when the [Status] is [Reserve], the field is blank.