Filter
Top Products
Chapter 5 Configuration Menu
> 5.4 Host Interface Management
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
426
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
The following explains the IOA Mapping setting procedures.
The following settings are available.
• Add/Change/Delete IOA Mapping
• Copy IOA Mapping
The following explains the procedures.
5.4.10.1 Add/Change/Delete IOA Mapping
This section explains procedures to add/change/delete IOA Mapping.
Procedure
1 Click [Set IOA Mapping] under the Host Interface Management in the
[Configuration] menu.
→ The [Set IOA Mapping (Initial)] screen appears.
• Make sure to stop the host ac c e s s t o t h e O C L I N K P o r t o r F C L I N K P o r t
to be changed/deleted when its IOA Mapping information is changed/
deleted during operation. When adding new IOA Mapping, it is not
necessary to stop the host access.
• When copying IOA Mapping information to an active OCLINK Port or
FCLINK Port, make sure to stop host access to the copy destination
OCLINK Port or FCLINK Port. To copy IOA Mapping information to a
newly added OCLINK Port or FCLINK Port, it is not necessary to stop
host access.
• Before creating IOA Mapping information, register LCUs in the
ETERNUS DX8100/DX8400/DX8700 using the [LCU Setting] function.
In the following cases, an error occurs and a message to that effect
appears. Click [OK] button to return to the [Menu] screen.
• When no LCU is registered
• When no Mainframe Volume or MVV Volume is created in the
ETERNUS DX8100/DX8400/DX8700
• When no OCLINK or FCLINK is installed