Filter
Top Products
Chapter 5 Configuration Menu
> 5.4 Host Interface Management
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
338
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
4 Click the [OK] button.
→ Displays the [Set Host World Wide Name(s) (Updating Configuration Information)]
screen. After the process is successfully completed, the [Set Host World Wide Name(s)
(Setting Result)] screen appears.
5 Click the [OK] button.
→ Returns to the [Menu] screen.
End of procedure
5.4.3 Set iSCSI Host
iSCSI Host information should be set only when the host and the ETERNUS DX400/DX8000
series
are connected via iSCSI-CA.
If the iSCSI Host information of the host-side host bus adapters are registered, the Host-Affinity
function can use them to restrict which hosts are allowed to access which
ETERNUS DX400/
DX8000 series
Logical Volume.
This function adds/changes/deletes iSCSI Host information without needing to stop ETERNUS
DX400/DX8000 series
.
When converting a Host Response from the ETERNUS DX400/DX8000 series to the host is nec-
essary, the Host Response must be assigned to each iSCSI Host information or each iSCSI-CA
Port. A target to which a Host Response is assigned varies depending on [ON/OFF] of the Host
Affinity function.
• When the Host-Affinity function is [ON (Enabled)]
Set Host Response for each iSCSI Host information using this function.
• When the Host-Affinity function is [OFF (Disabled)]
Set Host Response for each iSCSI-CA Port using the [Set CA Parameters] function.
The number of iSCSI Host differs depending on the ETERNUS DX400/DX8000 series.