Filter
Top Products
Chapter 6 Settings Menu
> 6.3 Advanced Copy Settings
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
457
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
The following explains the operating procedures of Set REC Priority.
Procedure
1 Click [Set REC Priority] under the Advanced Copy Settings in the [Settings]
menu.
→ The [Set REC Priority (Initial)] screen appears.
2 Click the Box ID of the remote device to perform priority setting.
→ The [Set REC Priority (Speed Setting)] screen appears.
Refer to "A.25.1 Set REC Priority (Speed Setting) Screen" (page 775) for screen
details.
3 Select the connection type, and click the [OK] button.
In the case of remote connection, specify the following items.
• Volume Type
Specify the Volume Type to be copied.
• Link Speed
Specify the real transfer rate of the line that the local device uses (bandwidth usable in
REC).
• Compression Ratio
Specify the average com pression rate of transfer data for the n etworking device's
compression function.
When no remote device is registered in the ETERNUS DX400/
DX8000 series, a message to that effect is displayed. Click [OK]
button to return to the [Menu] screen.
"Suspend" the session status between devices before executing the
[Set REC Priority] function in the following conditions. For other
conditions, it is not necessary to change the session status. You can
check the REC sessions by [Advanced Copy Status] function.
• When changing the connection type (Direct Connection/Remote
Connection)
• When clicking the [Refresh] button to measure the response time
again in the Remote Connection