Appendix A Screen Details
> A.6 Advanced Copy Status
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
700
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
■ Path information between devices
● Displayed contents
• Device CA information
- CM#
The CM number where the CA is installed is displayed.
- CA#
The CA number and the installed CA type (FCRA or iSCSI-RA) are displayed.
- Port#
The port number in the CA is displayed.
• Remote CA information
- Mode
Relevant port mode is displayed.
• A: Auto (interactive)
• I: Initiator (unidirectional transmission source) (*1)
• T: Target (unidirectional transmission destination) (*1)
- WWN/iSCSI Name
Remote device's World Wide Name (for FCRA), or iSCSI Name (for iSCSI-RA) is
displayed.
• Status
The path status between the local device and the remote device is displayed.
- When the port of the local device is [Auto] or [Target (*1)]
• Normal
The path status of the relevant port is normal.
• Warning (R)
The path status of the relevant port is unstable.
Refer to "Path status codes and troubleshooting (Warning)" for troubleshooting
methods when [Warning (R)] is displayed.
• Warning (B)
The bitmap ratio of the local device and the remote device differs in the port.
Refer to "Path status codes and troubleshooting (Warning)" for troubleshooting
methods when [Warning (B)] is displayed.
• Error (status code)
The path status of the relevant port is in error status.
When the path status is [Error] and the suspected location can be specified, the
location is displayed in ( ) with a code. Refer to the "Path status codes and
troubleshooting" when these codes are displayed.
• Unknown
Unknown path configuration details are found in the device.
When deleting a path configuration, delete the relevant information in the [Create
Advanced Copy Information] menu. And then set the updated path configuration file to
the device in the [Set Advanced Copy Path] menu.