Filter
Top Products
Chapter 6 Settings Menu
> 6.5 Eco-mode
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
521
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
6 Click the [OK] button.
→ Returns to the [Menu] screen.
End of procedure
6.5.3 Set RAID Group-Eco-mode
This function sets the Eco-mode schedule that is specified in the "Set Eco-mode Schedule" func-
tion in the RAID group and runs the schedule.
By specifying the Eco-mode schedule in the RAID group, disk motors in that RAID group can be
activated according to the schedule.
• Eco-mode is only available for Open/SDV Usage RAID groups. To use
Eco-mode, the storage system must contain at least one Open or SDV
Usage RAID group.
• To set the RAID Group-Eco-mode schedule, install at least one Eco-
mode schedule in the device.
• Occurrence of any of the following on an Eco-mode RAID group (disk
drive motors on) will prevent the disk drive motors from being stopped
based on the Eco-mode settings. Eco-mode will be re-enabled when the
interrupting process is resolved (finished, etc.):
- Target RAID group status is other than "Available"
- Rebuild or copyback is being executed on the target RAID group
- LDE is being executed on the target RAID group
- Volumes in the target RAID group are being formatted
- Volumes in the target RAID group are under RAID Migration
- Advanced Copy is being actively performed (when copy status is
other than "Suspended" or "Tracking") on volumes in the target RAID
Group
- Volumes in the target RAID group are being encrypted
- Snap Data Volumes are registered in the target RAID group