Filter
Top Products
Chapter 5 Configuration Menu
> 5.4 Host Interface Management
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
302
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
The following explains [Set CA Parameters] procedures.
The following operations can be performed in the [Set CA Parameters].
• Set Connection Information of a Connection between the CA and the Host
• Copy the Connection Information
These procedures are explained in the following sections.
5.4.1.1 Set Connection Information of a Connection between the CA and the Host
This section explains the procedures for how to set the connection information of a CA and host.
Procedure
1 Click [Set CA Parameters] under the Host Interface Management in the
[Configuration] menu.
→ The [Set CA Parameters (Initial)] screen appears.
2 Select the CA Port to set the connection information between the CA and the
host, and click the [Set] button.
If the CA type is FC, the settings can be copied between the ports with
same RA mode (FC-CA/FC-RA/RFCF-RA). However, settings cannot be
copied between FC4G and FC8G. Change the RA mode using the [Change
RA Mode] menu.