Filter
Top Products
1034 CHAPTER 73: BGP DEBUGGING COMMANDS
// Information about the sent VPLS update message
*0.92566 Sysname RM/7/RMDEBUG:
BGP.VPLS: Recv UPDATE from 1.1.1.1 with following destinations :
Update message length : 88
Origin : IGP
AS Path : 100
Next Hop : 1.1.1.1
afi = 155(vpls) safi = 128(vpls)
Route Distinguisher:100:1
CE-ID:0
label offset:0
label base:8192
// Information about the received VPLS update message
debugging bgp update vpn-instance
Syntax debugging bgp update vpn-instance vpn-instance-name [ ip-prefix ip-prefix-name |
peer { ipv4-address | group-name } ] [ receive | send ] [ verbose ]
undo debugging bgp update vpn-instance vpn-instance-name [ ip-prefix
ip-prefix-name | peer { ipv4-address | group-name } ] [ receive | send ] [ verbose ]
View User view
Default Level 1: Monitor level
Parameters vpn-instance-name: Enables/disables the BGP update message debugging for the
specified VPN instance.
ip-prefix ip-prefix-name: Filters the output message debugging information with
the specified IP prefix list.
peer { ipv4-address | group-name }: Enables/disables BGP update message
debugging for the specified peer/peer group.
receive: Enables/disables the debugging for received BGP packets.
send: Enables/disables the debugging for the sent BGP packets.
verbose: Displays detailed debugging information.
Description Use the
debugging bgp update vpn-instance command to enable update
message debugging for a BGP VPN instance.
Use the
undo debugging bgp update instance command to disable update
message debugging for a BGP VPN instance.
By default, this debugging is disabled.
Enabling debugging may affect system performance; therefore, use this command
only when necessary and disable debugging once the debugging operation is
complete.