Filter
Top Products
1141
Description Use the maximum-routes command to specify the maximum route number of a
specified type: inter-area, intra-area, external.
Use the
undo maximum-routes command to restore the default route
maximum value of a specified type.
Examples # Specify the maximum number of intra-area routes as 500.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] maximum-routes intra 500
network (OSPF area view)
Syntax network ip-address wildcard-mask
undo network ip-address wildcard-mask
View OSPF area view
Parameters ip-address: IP address of a network
wildcard-mask: Wildcard mask of the IP address. For example, the wildcard mask
for the subnet mask 255.0.0.0 is 0.255.255.255.
Description Use the
network command to enable OSPF on the interface attached to the
specified network in the area.
Use the
undo network command to disable OSPF on an interface.
By default, an interface neither belongs to any area nor runs OSPF.
You can configure one or multiple interfaces in an area to run OSPF. Note that the
interface’s primary IP address must fall into the specified network segment to
make the interface run OSPF. If only the interface’s secondary IP address falls into
the network segment, the interface cannot run OSPF.
Related commands: ospf.
Examples # Specify the interface whose primary IP address falls into 131.108.20.0/24 to run
OSPF in Area 2.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 2
[Sysname-ospf-100-area-0.0.0.2] network 131.108.20.0 0.0.0.255
nssa
Syntax nssa [ default-route-advertise | no-import-route | no-summary ]*