Filter
Top Products
583
Parameter digits: Maximum number of digits that can be sent each time in overlap-sending
mode, in the range 1 to 15. The default is 10.
Description Use the isdn overlap-sending command to set the system to send the called
number information in the overlap mode on the ISDN interface.
Use the
undo isdn overlap-sending command to set the system to send the
called information in full mode.
In overlap-sending mode, the digits of each called number will be sent separately
and the number of the digits sent each time can be set using this command.
In full-sending mode, all the digits of each called number will be collected and sent
at a time.
By default, full-sending mode applies.
You are not allowed to configure this command on an ISDN interface if there is still
a call on it. This command can take effect only if it is configured when there is no
call on the interface. Alternatively, you can manually disable the interface by
executing the shutdown command, configure the command, and then enable
the interface by executing the undo shutdown command. The operations,
however, will lead to the disconnection of the call existing on the interface.
n
Overlap-sending is only suitable for five ISDN protocols: ANSI, DSS1, ETSI, NI, and
QSIG.
Example # Apply the overlap-sending function on the interface BRI 1/0 and set the number
of digits allowed to send each time to 12 digits.
<Sysname> system-view
[Sysname] interface bri 1/0
[Sysname-Bri1/0] isdn overlap-sending 12
isdn pri-slipwnd-size
Syntax isdn pri-slipwnd-size window-size
isdn pri-slipwnd-size default
View Interface view
Parameter window-size: Slide window size in the range of 5 to 14. By default, the slide
window size on PRI interfaces is 7.
Description Use the
isdn pri-slipwnd-size command to set the slide window size on a PRI
interface.
Use the
isdn pri-slipwnd-size default command to restore the default slide
window size on the PRI interface.