Filter
Top Products
2282 CHAPTER 149: NQA CLIENT CONFIGURATION COMMANDS
[Sysname-nqa-admin-test-tcp] reaction 1 checked-element probe-fail
threshold-type consecutive 3 action-type trigger-only
reaction trap
Syntax reaction trap { probe-failure consecutive-probe-failures | test-complete | test-failure
cumulate-probe-failures }
undo reaction trap { probe-failure | test-complete | test-failure }
View Any NQA test type view
Parameter probe-failure consecutive-probe-failures: Specifies to send a trap to the network
management server after consecutive-probe-failures in an NQA test.
consecutive-probe-failures is the number of consecutive probe failures in a test, in
the range 1 to 15.
test-complete: Specifies to send a trap to indicate that the test is completed.
test-failure cumulate-probe-failures: Specifies to send a trap to the network
management server if the total number of probe failures in an NQA test is larger
than or equal to cumulate-probe-failures. For one test, the trap is sent only when
the test is completed. cumulate-probe-failures is the total number of consecutive
probe failures in a test, in the range 1 to 15.
Description Use the
reaction trap probe-fail command to configure to send traps to
network management server under specified conditions.
Use the
undo reaction trap probe-fail command to restore the default.
By default, no traps are sent to the network management server.
Example # Configure to send a trap after five consecutive probe failures in an ICMP-echo
test.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction trap probe-failure 5
route-option bypass-route
Syntax route-option bypass-route
undo route-option bypass-route
View DLSw/FTP/HTTP/ICMP-echo/SNMP/TCP/UDP-echo/UDP-jitter test type view
Parameter None