Filter
Top Products
1703
View BGP view/BGP VPN instance view
Parameter group-name: Name of the peer group, a string of 1 to 47 characters.
ip-address: IP address of the peer.
Description Use the
peer label-route-capability command to enable the exchange of
labeled routes with an IPv4 peer or peer group.
Use the
undo peer label-route-capability command to disable the capability.
By default, the device does not advertise labeled routes to an IPv4 peer.
According to the networking scheme, the peer label-route-capability command
enables the exchange of labeled IPv4 routes with:
■ ASBR PEs in the same AS.
■ PEs in the same AS.
■ the peer ASBR PE.
Example # Specify to exchange labeled IPv4 routes with peer 2.2.2.2.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer 2.2.2.2 label-route-capability
peer next-hop-invariable (BGP-VPNv4 subaddress family view)
Syntax peer { group-name | ip-address } next-hop-invariable
undo peer { group-name | ip-address } next-hop-invariable
View BGP-VPNv4 subaddress family view
Parameter group-name: Name of the peer group, a string of 1 to 47 characters.
ip-address: IP address of the peer.
Description Use the
peer next-hop-invariable command to configure the device not to
change the next hop of a route when advertising it to an EBGP peer.
Use the
undo peer next-hop-invariable command to restore the default.
By default, a device uses its address as the next hop when advertising a route to its
EBGP peer.
Related command:. peer ebgp-max-hop (BGP/BGP-VPN instance view) on page 991
Example # In BGP-VPNv4 subaddress family view, configure the device not to change the
next hop of a route when advertising it to EBGP peer 1.1.1.1.