Filter
Top Products
1691
# Display information about OSPF sham links in area 1.
<Sysname> display ospf sham-link area 1
OSPF Process 100 with Router ID 100.1.1.2
Sham-Link: 3.3.3.3 --> 5.5.5.5
Neighbour State: Full
Area: 0.0.0.1
Cost: 10 State: P-2-P, Type: Sham
Timers: Hello 10 , Dead 40 , Retransmit5,Transmit Delay 1
display tunnel-policy
Syntax display tunnel-policy { all | policy-name tunnel-policy-name }
View Any view
Parameter all: Specifies all tunneling policies.
tunnel-policy-name: Name of a tunneling policy, a string of 1 to 19 characters.
Description Use the
display tunnel-policy command to display information about a
tunneling policy or all tunneling policies.
Related command: tunnel-policy, tunnel select-seq load-balance-number.
Example # Display all tunneling policies.
<Sysname>display tunnel-policy all
Tunnel Policy Name Select-Seq Load balance No
------------------------------------------------------
RouterId Router ID of the sham link
Source-IP Source IP address of the sham link
Destination-IP Destination IP address of the sham link
State Status of the sham link interface
Cost Cost of the sham link
Table 460 Description on the fields of the display ospf sham-link area command
Field Description
Sham-Link Sham link expressed in the format of source IP address to destination
IP address
Neighbor State Status of the sham link neighbor
Area Destination IP address of the sham link
Cost Cost of the sham link
State Status of the sham link
Type Type of the sham link
Timers Timers of the sham link
Table 459 Description on the fields of the display ospf sham-link command
Field Description