Filter
Top Products
2291
Note that:
■ You need to configure the command on the NQA server for TCP tests only.
■ The IP address and port number must be consistent with those on the NQA
client and must be different from those for an existing listening service.
■ The IP address must be that of an interface on the NQA server. Otherwise, the
configuration will be invalid.
Related command: nqa server enable.
Example # Create a TCP listening service by using the IP address 169.254.10.2 and port
9000.
<Sysname> system-view
[Sysname] nqa server tcp-connect 169.254.10.2 9000
nqa server udp-echo
Syntax nqa server udp-echo ip-address port-number
undo nqa server udp-echo ip-address port-number
View System view
Parameter ip-address: IP address specified for the UDP listening service on the NQA server.
port-number: Port number specified for the UDP listening service on the NQA
server, in the range 1 to 50000.
Description Use the
nqa-server udpecho command to create a UDP listening service on the
NQA server.
Use the
undo nqa-server udpecho command to remove the UDP listening
service created.
Note that:
■ You need to configure the command on the NQA server for UDP-jitter and
UDP-echo tests only.
■ The IP address and port number must be consistent with those configured on
the NQA client and must be different from those of an existing listening
service.
■ The IP address must be that of an interface on the NQA server. Otherwise, the
configuration will be invalid.
Related command: nqa server enable.
Example # Create a UDP listening service by using the IP address 169.254.10.2 and port
9000.