Filter
Top Products
2151
Description Use the tunnel local command to configure the local address of an IPSec tunnel.
Use the undo tunnel local command to remove the configuration.
By default, no local address is configured for an IPSec tunnel.
Note that:
■ This command applies to only manual IPSec policies.
■ The local address, if not configured, will be the address of the interface to
which the IPSec policy is applied.
Related command: ipsec policy (system view).
Example # Set the local address of the IPSec tunnel to the address of Loopback0, namely
10.0.0.1.
<Sysname> system-view
[Sysname] interface loopback 0
[Sysname-LoopBack0] ip address 10.0.0.1 32
[Sysname-LoopBack0] quit
[Sysname] ipsec policy policy1 100 manual
[Sysname-ipsec-policy-manual-policy1-100] tunnel local 10.0.0.1
tunnel remote
Syntax tunnel remote ip-address
undo tunnel remote [ ip-address ]
View IPSec policy view
Parameter ip-address: Remote address for the IPSec tunnel.
Description Use the
tunnel remote command to configure the remote address of an IPSec
tunnel.
Use the
undo tunnel remote command to remove the configuration.
By default, no remote address is configured for the IPSec tunnel.
Note that:
■ This command applies to only manual IPSec policies.
■ If you configure the remote address repeatedly, the last one takes effect.
■ An IPSec tunnel is established between the local and remote ends. The remote
IP address of the local end must be the same as that of the local IP address of
the remote end.
Related command: ipsec policy (system view).