Filter
Top Products
1426 CHAPTER 90: PIM CONFIGURATION COMMANDS
Example # Set the state refresh interval to 70 seconds in the public instance.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-interval 70
state-refresh-rate-limit (PIM view)
Syntax state-refresh-rate-limit interval
undo state-refresh-rate-limit
View Public instance PIM view, VPN instance PIM view
Parameter interval: Time to wait before receiving a new refresh message, in seconds and with
an effective range of 1 to 65535.
Description Use the
state-refresh-rate-limit command to configure the time the router
must wait before receiving a new state refresh message.
Use the
undo state-refresh-rate-limit command to restore the default setting.
By default, the device waits 30 seconds before receiving a new state refresh
message.
Related command: pim state-refresh-capable, state-refresh-interval (PIM view), and
state-refresh-ttl (PIM view).
Example # In the public instance configure the device to wait 45 seconds before receiving a
new state refresh message.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-rate-limit 45
state-refresh-ttl (PIM view)
Syntax state-refresh-ttl ttl-value
undo state-refresh-ttl
View Public instance PIM view, VPN instance PIM view
Parameter ttl-value: TTL value of state refresh messages, in the range of 1 to 255.
Description Use the
state-refresh-ttl command to configure the TTL value of state refresh
messages.
Use the
undo state-refresh-ttl command to restore the default setting.