Filter
Top Products
1625
n
The mpls te igp shortcut command cannot be used together with the mpls te
igp advertise command.
Example # Enable OSPF and IS-IS to consider TE tunnel 0 in enhanced SPF calculation when
the tunnel is up.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te igp shortcut
mpls te link administrative group
Syntax mpls te link administrative group value
undo mpls te link administrative group
View Interface view
Parameter value: Link administrative group attribute, in the range 0x00000000 to 0xFFFFFFFF.
It is a set of 32 link properties. Each bit represents a property with a value of 0 or
1. By ANDing the administrative group attribute bits with the corresponding link
affinity attribute bits of an MPLS TE tunnel, MPLS TE identifies the properties of
the links that the MPLS TE tunnel can use.
Description Use the
mpls te link administrative group command to configure the link
administrative group attribute.
Use the
undo mpls te link administrative group command to restore the
default.
The default link administrative group attribute is 0x00000000.
The interface properties are propagated globally and are used for path selection at
the tunnel ingress.
Related command: mpls te affinity property.
Example # Assign interface Ethernet 1/0 the link administrative group attribute of
0x00000101.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mpls te link administrative group 101
mpls te loop-detection
Syntax mpls te loop-detection
undo mpls te loop-detection