Filter
Top Products
561
By default, bridging over a PVC is disabled. If you configure both the map bridge
virtual-ethernet and map bridge-group commands, only the map bridge
virtual-ethernet takes effect.
Example # Enable bridging over PVC 32/102.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] pvc 32/102
[Sysname-atm-pvc-Atm1/0-32/102] map bridge-group broadcast
reset bridge address-table
Syntax reset bridge address-table [ bridge-set bridge-set | dlsw | interface interface-type
interface-number ]
View User view
Parameters bridge-set: Clears MAC address entries of the specified bridge set. bridge-set must
be an integer in the range of 1 to 255.
dlsw: Clears MAC address entries of the DLSw module.
interface-type interface-number: Clears MAC address entry of the specified
interface.
Description Use the reset bridge address-table command to remove one or more dynamic
bridge table entries.
Example # Clear all dynamic entries about bridge set 1 from the bridge table.
<Sysname> reset bridge address-table bridge-set 1
reset bridge traffic
Syntax reset bridge traffic [ bridge-set bridge-set | dlsw | interface interface-type
interface-number ]
View User view
Parameters bridge-set: Clears traffic statistics information about the specified bridge set.
bridge-set must be an integer in the range of 1 to 255.
dlsw: Clears the traffic statistics information about the DLSw module.
interface-type interface-number: Clears the traffic statistics information about the
specified interface.
Description Use the reset bridge traffic command to clear the statistic information about
bridged traffic.