Filter
Top Products
933
verbose: Displays detailed routing table information, including that for inactive
routes. With this argument absent, the command displays only brief information
about active routes.
Description Use the
display ip routing-table acl command to display information about
routes permitted by a specified basic ACL.
This command is intended for the follow-up display of routing policies.
For more information about routing policy, refer to “Routing Policy Common
Configuration Commands” on page 1187.
n
If the specified ACL does not exist or it has no rules configured, the entire routing
table is displayed.
Examples # Define basic ACL 2000 and set the route filtering rules.
<Sysname > system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.0.0 0.0.255.255
[Sysname-acl-basic-2000] rule deny source any
# Display brief information about active routes permitted by basic ACL 2000.
[Sysname-acl-basic-2000] display ip routing-table acl 2000
Routes Matched by Access list : 2000
Summary Count : 6
Destination/Mask Proto Pre Cost NextHop Interface
10.1.1.0/24 Direct 0 0 10.1.1.2 Vlan1
10.1.1.2/32 Direct 0 0 127.0.0.1 InLoop0
10.1.2.0/24 Direct 0 0 10.1.2.1 Eth1/0
10.1.2.1/32 Direct 0 0 127.0.0.1 InLoop0
10.1.3.0/24 Direct 0 0 10.1.3.1 Eth1/1
10.1.3.1/32 Direct 0 0 127.0.0.1 InLoop0
For detailed description of the above output, see Table 202.
# Display detailed information about both active and inactive routes permitted by
basic ACL 2000.
<Sysname> display ip routing-table acl 2000 verbose
Routes Matched by Access list : 2000
Summary Count: 6
Destination: 10.1.1.0/24
Protocol: Direct Process ID: 0
Preference: 0 Cost: 0
NextHop: 10.1.1.2 Interface: Vlan1
RelyNextHop: 0.0.0.0 Neighbour: 0.0.0.0
Tunnel ID: 0x0 Label: NULL
State: Active Adv Age: 00h25m32s
Tag: 0
Destination: 10.1.1.2/32