Filter
Top Products
1478 CHAPTER 93: IPV6 PIM CONFIGURATION COMMANDS
embedded-rp
Syntax embedded-rp [ acl6-number ]
undo embedded-rp [ acl6-number ]
View IPv6 PIM view
Parameter acl6-number: Basic IPv6 ACL number, in the range of 2000 to 2999.
Description Use the
embedded-rp command to enable embedded RP.
Use the undo embedded-rp command to disable embedded RP or restore the
default configuration.
By default, any IPv6 multicast group in the default embedded RP address ranges
can use the embedded RP function.
n
The default embedded RP address ranges are FF7x::/12 and FFFx::/12, where x
represents any legal scope.
For details about the scope field, refer to “MPLS Basics Configuration Commands”
on page 1513.
Note that:
■ When you use the embedded-rp command without specifying acl6-number,
the embedded RP feature will be enabled for all the IPv6 multicast groups in
the default embedded RP address scopes; if you specify acl6-number, the
embedded RP feature will be enabled for only those IPv6 multicast groups that
are within the default embedded RP address scopes and pass the ACL check.
■ When you use the undo embedded-rp command without specifying
acl6-number, the embedded RP feature will be disabled for all the IPv6
multicast groups; if you specify acl6-number, this command will restore the
system default.
Example # Enable embedded RP for the IPv6 multicast groups in the range of
FF7E:140:20::101/64.
Table 362 Description on the fields of the display pim ipv6 rp-info command
Field Description
prefix/prefix length The IPv6 multicast group served by the RP
RP IPv6 address of the RP
Priority RP priority
HoldTime Timeout time of the RP
Uptime Length of time since the RP was elected
Expires Remaining time of the RP