Filter
Top Products
991
Use the undo peer description command to remove the description
information of a peer/peer group.
By default, no description information is configured for a peer/peer group.
Create a peer/peer group before configuring a description for it.
Related commands: display bgp peer.
Examples # In BGP view, configure the description information of the peer group test as
ISP1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test description ISP1
# In BGP-VPN instance view, configure the description information of the peer
group test as ISP1(the VPN has been created).
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-vpn1] peer test description ISP1
peer ebgp-max-hop (BGP/BGP-VPN instance view)
Syntax peer { group-name | ip-address } ebgp-max-hop [ hop-count ]
undo peer { group-name | ip-address } ebgp-max-hop
View BGP view/BGP-VPN instance view
Parameters group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
hop-count: Maximum hop count, in the range 1 to 255. The default is 64.
Description Use the
peer ebgp-max-hop command to allow establishing an EBGP
connection with a peer/peer group that is on an indirectly connected network.
Use the
undo peer ebgp-max-hop command to restore the default.
By default, this feature is disabled.
You can use the argument hop-count to specify the maximum route count of the
EBGP connection.
Examples # In BGP view, allow establishing the EBGP connection with the peer group test
that is on an indirectly connected network.