Filter
Top Products
1594 CHAPTER 96: MPLS TE CONFIGURATION COMMANDS
121400
131500
141600
151700
display mpls te tunnel
Syntax display mpls te tunnel [ destination dest-addr ] [ lsp-id lsr-id lsp-id ] [ lsr-role { all |
egress | ingress | remote | transit }] [name name ] [ { incoming-interface |
outgoing-interface | interface } interface-type interface-number ] [ verbose ]
View Any view
Parameter destination address: Specifies a destination IP address to display only the tunnels
with the specified destination IP address.
lsr-id: LSR ID of the ingress node, in dotted decimal notation.
lsp-id: LSP ID, in the range 1 to 65535.
lsr-role: Displays tunnels by LSR role (ingress, transit, egress, or remote).
all: Displays all tunnels.
ingress: Displays tunnels created taking current device as the ingress.
transit: Displays tunnels created taking current device as a transit node.
egress: Displays tunnels created taking current device as the egress.
name name: Displays the tunnel with a particular name. This could be a string of
1 to 63 characters configured as interface description or the interface name if no
interface description is configured. The tunnel name should be signaled to all
hops.
Table 412 Description on the fields of the command
Field Description
Link ID Link ID
Physical Bandwidth Type0 CT0 physical bandwidth
Physical Bandwidth Type1 CT1 physical bandwidth
Reservable Bandwidth Type0 CT0 reservable bandwidth
Reservable Bandwidth Type1 CT1 reservable bandwidth
Downstream LSP Count Number of downstream LSPs
UpStream LSP Count Number of upstream LSPs
IPUpdown Link Status IP layer link status
PhysicalUpdown Link Status Physical layer link status
TE CLASS TE class
CLASS TYPE Service class type
PRIORITY Priority
BW RESERVED Reserved bandwidth