Filter
Top Products
660 CHAPTER 44: LOGICAL INTERFACE CONFIGURATION COMMANDS
display interface mp-group
Syntax display interface mp-group [ mp-number ]
View Any view
Parameter mp-number: Multilink point to point protocol group (MP-group) interface number,
which can be the number of any existing MP-group interface.
Description Use the
display interface mp-group command to view the state information
about the existing MP-group interfaces. If you do not provide an MP-group
interface number, this command will display the state information about all the
existing MP-group interfaces.
Related command: interface mp-group.
Example # View the state information of MP-group 12.
<Sysname> display interface mp-group 12
Mp-group12 current state: DOWN
Line protocol current state: DOWN
Description: Mp-group12 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet protocol processing : disabled
Link layer protocol is PPP
LCP initial
Physical is MP
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec 0 packets/sec
Last 300 seconds output: 0 bytes/sec 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Output queue : (Urgent queue :
Size/Length/Discards)
Output queue : (Protocol queue :
Size/Length/Discards)
Output queue : (FIFO queuing :
Size/Length/Discards)
Last 300 seconds input: 0 bytes/sec,
0 packets/sec
Last 300 seconds output: 0
bytes/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Statistics on packets sent/received over the physical
layer
Table 118 Description on the fields of the display interface mfr command
Field Description