Filter
Top Products
515
Example # Configure the interface serial 1/0 to allocate the IP address 10.0.0.1 to the peer.
The peer may accept this assigned address, or use its self-configured address, or
have no IP address.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] remote address 10.0.0.1
# Configure the interface serial 1/0 to allocate the IP address 10.0.0.1 to the peer.
The peer must accept this allocated address and cannot use its self-configured
address or go without IP address.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] remote address 10.0.0.1
[Sysname-Serial1/0] ppp ipcp remote-address forced
ppp lqc
Syntax ppp lqc close-percentage [ resume-percentage ]
undo ppp lqc
View Interface view
Parameter close-percentage: If the link quality decreases below this percentage, the link will
go down. The value ranges from 0 to 100.
resume-percentage: If the link quality recovers above this percentage, the link will
go up. The value ranges from 0 to 100.
Description Use the
ppp lqc command to enable PPP link quality control (LQC).
Use the
undo ppp lqc command to disable PPP link quality control.
By default, PPP LQC is disabled.
By default, the arguments resume-percentage and close-percentage are equal. But
in actual configuration, the resume-percentage must not be smaller than
close-percentage.
PPP LQC functions to monitor the quality of PPP links, including those in MP
bundles. A link goes down when its quality drops below the close percentage and
goes up when its quality exceeds the resume-percentage. To avoid flapping, a link
experiences a delay before it is reused.
Before you enable PPP LQC, the PPP interface sends keepalives to the peer every
some time. After you enable LQC on the interface, it sends link quality reports
(LQRs) instead of keepalives to monitor the link.
When link quality is normal, the system calculates link quality based on each LQR
and disables the link if the results of two consecutive calculations are below the
close-percentage. Once the link is disabled, the system starts to calculate link