Filter
Top Products
2594 CHAPTER 173: VOIP CONFIGURATION COMMANDS
View E&M voice subscriber line view
Parameter delay: When using the delay start mode, the calling end occupies the trunk line,
and the called end, such as PBX, will also enter the hook-off state to respond the
caller till it is ready for receiving the called number.
immediate: Immediate start mode. The caller end hooks off to seize the line
through line E and sends the called number. The prerequisite for using the
immediate start mode is: The equipment at the remote end should listen to the
dial signal immediately after identifying the off-hook signal.
wink: Wink start mode. The caller end hooks off to seize the line through line E,
and it has to wait for a wink signal from the remote end before sending out the
called number.
Description Use the
em-signal command to configure a start mode for an analog E&M voice
subscriber line.
Use the
undo em-signal command to restore the default start mode.
By default, the immediate start mode is selected for the analog E&M subscriber
line.
Related command: delay.
Example # Configure delay mode.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] em-signal delay
entity
Syntax entity entity-number { pots | voip }
undo entity { entity-number | all | pots | voip }
View Voice dial program view
Parameter entity-number: Identifies a voice entity. The value ranges from 1 to 2147483647.
all: All voice entities.
pots: Indicates that the voice entity originates a call from the local voice subscriber
line.
voip: Indicates that the voice entity originates a call from the network side.
Description Use the
entity command to enter voice entity view, or configure a voice entity
and then enter its view if the voice entity does not exist.