Filter
Top Products
333
interface dialer
Syntax interface dialer number
undo interface dialer number
View System view
Parameter number: Dialer interface number, in the range 0 to 1023.
Description Use the
interface dialer command to create a dialer interface. In C-DCC, this
equals creating a dialer circular group.
Use the
undo interface dialer command to remove a dialer interface.
By default, no dialer interface is created.
The dialer interface has a fixed baudrate of 64,000 bps.
In C-DCC, you may assign multiple physical interfaces to a dialer interface to
inherit the attributes of this dialer interface by assigning them to the dialer circular
group for the dialer interface with the dialer circular-group command. This is
efficient where calling multiple destinations simultaneously is desired, because
instead of configuring individual physical interfaces, you only need to configure
multiple dialer routes on the dialer interface.
In RS-DCC, any dialer interface can use the services provided by multiple physical
interfaces, and individual physical interfaces can provide services for multiple dialer
interfaces at the same time. Therefore, authentication must be configured on
these physical interfaces, so as to use the username of a dial-in party to locate the
corresponding dialer interface for the call. In this mode, physical interfaces and
dialer interfaces are dynamically bound. Furthermore, a dialer interface can only
call a destination address as specified in the dialer number command.
LCP initial LCP is initialized.
Physical is Dialer The physical interface is a dialer interface.
Output queue : (Urgent queuing :
Size/Length/Discards)
Statistics on the packets in the urgent output queue
Output queue : (Protocol queuing
: Length)
Statistics on the packets in the protocol output queue
Output queue : (FIFO queuing :
Size/Length/Discards)
Statistics on the packets in the FIFO output queue
Last 300 seconds input: 0
bytes/sec, 0 packets/sec
Input interface data rate during the latest 300 seconds
Last 300 seconds output: 0
bytes/sec, 0 packets/sec
Output interface data rate during the latest 300 seconds
0 packets input, 0 bytes, 0 drops Statistics on the packets reaching the interface
0 packets output, 0 bytes, 0 drops Statistics on the packets sent through the interface
Table 32 Description on the fields of the display interface dialer command
Field Description