Filter
Top Products
1208 CHAPTER 79: IPV4 ROUTING POLICY CONFIGURATION COMMANDS
Description Use the display ip ip-prefix command to display the statistics of an IPv4 address
prefix list. If no ip-prefix-name is specified, statistics for all IPv4 address prefix lists
will be displayed.
Related commands: ip ip-prefix.
Examples # Display the statistics of IPv4 prefix list abc.
<Sysname> display ip ip-prefix abc
Prefix-list abc
Permitted 0
Denied 0
index: 10 permit 1.0.0.0/11 ge 22 le 32
if-match acl
Syntax if-match acl acl-number
undo if-match acl
View Routing policy view
Parameters acl-number: ACL number from 2000 to 3999.
Description Use the
if-match acl command to configure an ACL match criterion.
Use the
undo if-match command to remove the match criterion.
No ACL match criterion is configured by default.
Related commands: if-match interface, if-match ip next-hop, if-match cost, if-match tag,
route-policy, apply ip-address next-hop, apply cost, apply local-preference,
apply origin,apply tag.
Examples # Create routing policy policy1 with node 10, matching mode as permit. Define
an if-match clause to permit routes matching ACL 2000.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match acl 2000
Table 285 Description on the fields of the display ip ip-prefix command.
Field Description
Prefix-list Name of the IPv4 prefix list
Permitted Number of routes satisfying the match criterion
Denied Number of routes not satisfying the match criterion
index Internal serial number of the IPv4 prefix list
permit Matching mode: permit or deny
1.0.0.0/11 Match IP address and mask
ge greater-equal, the lower limit mask
le less-equal, the upper limit mask