Filter
Top Products
1261
View IPv6 address family view
Parameters external-preference: Preference of EBGP route learned from an EBGP peer, in the
range 1 to 255.
internal-preference: Preference of IBGP route learned from an IBGP peer, in the
range 1 to 255.
local-preference: Preference of IPv6 BGP local route, in the range 1 to 255.
route-policy-name: Routing policy name, a string of 1 to 19 characters. The
routing policy can set a preference for routes passing it. To the routes filtered out,
the default value applies.
Description Use the
preference command to configure preferences for EBGP, IBGP, and local
routes.
Use the
undo preference command to restore the default.
The bigger the preference value is, the lower the preference is. The default values
of external-preference, internal-preference and local-preference are 255, 255 and
130 respectively.
Examples # Configure preferences for EBGP, IBGP, and local routes as 20, 20 and 200.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] preference 20 20 200
reflect between-clients (IPv6 address family view)
Syntax reflect between-clients
undo reflect between-clients
View IPv6 address family view
Parameters None
Description Use the
reflect between-clients command to enable route reflection between
clients.
Use the
undo reflect between-clients command to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects routes between clients. If the clients
are fully meshed, it is recommended to disable route reflection on the route
reflector to reduce costs.