Filter
Top Products
2738 CHAPTER 180: VOICE RADIUS CONFIGURATION COMMANDS
Use the undo password-digit command to restore the default number of digits
in a password for some access number in the card number/password process.
This command is unavailable for the caller number process with IVR. By default,
the number of digits in a password for some access number in the card
number/password process is 6.
Before executing the password-digit command, you must use the
process-config command to specify the two-stage dialing process for the
configured access number as card number/password process. The
password-digit command is available only in access number view.
Related command: gw-access-number and process-config.
Example # Specify the number of digits in a password as 4 for the access number 17909.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] gw-access-number 17909
[Sysname-voice-dial-anum17909] process-config cardnumber
[Sysname-voice-dial-anum17909] password-digit 4
# Restore the default number of digits in a password for the access number
17909.
[Sysname-voice-dial-anum17909] undo password-digit
process-config
Syntax process-config { callernumber | cardnumber | voice-caller }
undo process-config
View Access number view
Parameter callernumber: Specifies the two stage-dialing process as caller number process.
After a user dials an access number, the voice gateway will continue to play dial
tones, prompting for a called number. In this process, the user authentication is
implemented by identifying the calling number, and no more additional parameter
configurations are required.
cardnumber: Specifies the two-stage dialing process as card number/password
process. After a user dials an access number, the voice gateway will continue to
play prompt tones, requiring the user to enter a card number and password. In this
process, the user authentication is implemented by identifying the prepaid card
number and password, and you can configure parameters by using the card-digit,
password-digit, and redialtimes commands.
voice-caller: Specifies the two-stage dialing process as caller number process with
IVR. After a user dials an access number, the voice gateway will play prompt tones,
requiring the user to dial a called number. In this process, the user authentication