Filter
Top Products
1310 CHAPTER 85: IPV6 RIPNG CONFIGURATION COMMANDS
By default, the default metric of redistributed routes is 0.
The specified default metric applies to routes redistributed by the import-route
command that has no metric specified.
Related commands: import-route.
Examples # Set the default metric of redistributed routes to 2.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] default cost 2
display ripng
Syntax display ripng [ process-id ]
View Any view
Parameters process-id: RIPng process number, in the range of 1 to 65535.
Description Use the
display ripng command to display the running status and configuration
information of a RIPng process. If process-id is not specified, information of all
RIPng processes will be displayed.
Examples # Display the running status and configuration information of all configured RIPng
processes.
<Sysname> display ripng
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 3
Update time : 30 sec(s) Timeout time : 180 sec(s)
Suppress time : 120 sec(s) Garbage-Collect time : 120 sec(s)
Number of periodic updates sent : 0
Number of trigger updates sent : 0
Table 316 Description on the fields of the display ripng command
Field Description
RIPng Process RIPng process number
Preference RIPng route priority
Checkzero Whether zero field check for RIPng packet
headers is enabled
Default Cost Default metric of redistributed routes
Maximum number of balanced paths Maximum number of load balanced routes
Update time RIPng updating interval, in seconds
Timeout time RIPng timeout interval, in seconds
Suppress time RIPng suppress interval, in seconds
Garbage-Collect time RIPng garbage collection interval, in seconds