Filter
Top Products
2238 CHAPTER 147: VRRP CONFIGURATION COMMANDS FOR IPV6
<Sysname> display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Interface : Ethernet1/0
VRID : 1 Adver. Timer : 100
Admin Status : UP State : Master
Config Pri : 100 Run Pri : 100
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Track IF : Ethernet1/1 Pri Reduced : 10
Virtual IP : FE80::1
Virtual MAC : 0000-5e00-0201
Master IP : FE80::20F:E2FF:FE00:1234
display vrrp ipv6 statistics
Syntax display vrrp ipv6 statistics [ interface interface-type interface-number [ vrid
virtual-router-id ]]
View Any view
Table 590 Description on the fields of the display vrrp ipv6 command
Field Description
Run Method Current VRRP running mode, real MAC or virtual MAC
Virtual IP Ping Whether you can ping the virtual IPv6 address
Interface Interface to which the standby group belongs
VRID Number of the standby group
Adver. Timer VRRP advertisement interval in centiseconds
Admin Status Administrative state: UP or DOWN
State Status of the router in the standby group, master, backup, or initialize
Config Pri Configured priority
Run Pri Running priority
Preempt Mode Preemption mode
Delay Time Preemption delay
Auth Type Authentication type
Track IF The interface to be tracked. It is displayed only after the execution of the
vrrp ipv6 vrid track command.
Pri Reduced The priority value that is reduced when the interface being tracked is
down.
It is displayed only after the execution of the vrrp ipv6 vrid track
command.
Virtual IP Virtual IPv6 addresses of the standby group
Virtual MAC Virtual MAC address corresponding to the virtual IPv6 address of the
standby group. It is displayed only when the router is in the state of
master.
Master IP Primary IPv6 address of the interface to which the router in the state of
master belongs