Filter
Top Products
2442 CHAPTER 163: INFORMATION CENTER CONFIGURATION COMMANDS
info-center synchronous
Syntax info-center synchronous
undo info-center synchronous
View System view
Parameter None
Description Use the
info-center synchronous command to enable synchronous information
output.
Use the
undo info-center synchronous command to disable the synchronous
information output.
By default, the synchronous information output is disabled.
n
■ Under the current command line prompt, if the user’s input is interrupted by
system output such as log information, then after the completion of system
output the system will not display command line prompt.
■ When users need to input some interactive information (non Y/N confirmation
information) if the user’s input is interrupted by system information, then after
the completion of system output the system will not display command line
prompt but just print the user’s input.
Example # Enable synchronous information output.
<Sysname> system-view
[Sysname] info-center synchronous
% Info-center synchronous output is on
# The user receives trap messages when he/she is about to display the
configurations for an Ethernet interface by inputting the display interface ethe
command. After the system has finished its output of trap messages, it will display
the user’s original input, which is “display interface ethe” in this case.
<Sysname> system-view
[Sysname] display interface ethe
%Apr 29 08:12:44:71 2007 AR29.43 IFNET/4/LINK UPDOWN:
Ethernet2/1: link status is UP
[Sysname] display interface ethe
info-center timestamp
Syntax info-center timestamp { debugging | log | trap } { boot | date | none }
undo info-center timestamp { debugging | log | trap }
View System view