Filter
Top Products
1394 CHAPTER 90: PIM CONFIGURATION COMMANDS
Description Use the display pim claimed-route command to view the information of
unicast routes used by PIM.
If an (S, G) is marked SPT, this (S, G) entry uses a unicast route.
Example # View the information of all unicast routes used by PIM in the public instance.
<Sysname> display pim claimed-route
Vpn-instance: public net
RPF information about: 172.168.0.0
RPF interface: Ethernet1/1, RPF neighbor: 172.168.0.2
Referenced route/mask: 172.168.0.0/24
Referenced route type: unicast (direct)
RPF-route selecting rule: preference-preferred
The (S,G) or (*,G) list dependent on this route entry
(172.168.0.12, 227.0.0.1)
display pim control-message counters
Syntax display pim [ vpn-instance vpn-instance-name | all-instance ] control-message
counters [ message-type { probe | register | register-stop } | [ interface
interface-type interface-number | message-type { assert | bsr | crp | graft | graft-ack |
hello | join-prune | state-refresh }] *]
View Any view
Parameter vpn-instance-name: VPN instance name, a case sensitive string of up to 31
characters.
all-instance: Specifies all VPN instances.
probe: Displays the number of null register messages.
register: Displays the number of register messages.
register-stop: Displays the number of register-stop messages.
interface interface-type interface-number: Displays the number of PIM control
messages on the specified interface.
assert: Displays the number of assert messages.
bsr: Displays the number of bootstrap messages.
Table 336 Description on the fields of the display pim claimed-route command
Field Description
RPF interface RPF interface type and number
RPF neighbor IP address of the RPF neighbor
Referenced route/mask Address/mask of the referenced route
Referenced route type Type of the referenced route
RPF-route selecting rule Rule of RPF route selection
The (S,G) or (*,G) list dependent on this route entry (S,G) or (*, G) entries using this route