Filter
Top Products
1617
seconds: Automatic bandwidth adjustment/information collection interval, in the
range 300 to 604800 seconds. This value cannot be less than the sampling interval
configured by the mpls te timer auto-bandwidth command.
max-bandwidth: Upper limit for bandwidth tuning, in the range 1 to 32000000
kbps.
min-bandwidth: Lower limit for bandwidth tuning, in the range 1 to 32000000
kbps.
Description Use the
mpls te auto-bandwidth adjustment command to enable automatic
bandwidth adjustment for the tunnel.
Use the
mpls te auto-bandwidth collect-bw command to enable output rate
collection.
Use the
undo mpls te auto-bandwidth adjustment command to disable
automatic bandwidth adjustment and output rate collection on the tunnel.
By default, automatic bandwidth adjustment and output rate collection are
disabled.
If automatic bandwidth adjustment is enabled, bandwidth tuning happens every
24 hours without upper and lower bandwidth limits.
n
■ Support for this command varies by default.
■ Automatic bandwidth adjustment cannot be used together with these
commands: mpls te reoptimization, mpls te route-pinning, mpls te
backup, and mpls te resv-style ff.
Related command: mpls te timer auto-bandwidth.
Example # Automatically tune bandwidth for tunnel 0 hourly.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te auto-bandwidth adjustment frequency 3600
mpls te backup
Syntax mpls te backup { hot-standby | ordinary }
undo mpls te backup
View Tunnel interface view
Parameter hot-standby: Sets the backup mode to hot backup for the tunnel.
ordinary: Sets the backup mode to ordinary backup for the tunnel.
Description Use the
mpls te backup command to set the backup mode on the tunnel.