Filter
Top Products
2470 CHAPTER 164: USER INTERFACE CONFIGURATION COMMANDS
Parameter all: Sends messages to all user interfaces.
num1: Absolute number of a user interface. The value range varies with devices,
and normally starts from 0.
num2: Relative number of a user interface, in the following rules:
■ For the AUX port, the value is 0.
■ For the Console port, the value is 0.
■ For TTY user interfaces, the value range varies with devices, and normally starts
from 1.
■ For VTY user interfaces, the value ranges from 0 to 4.
Description Use the
send command to send messages to the specified user interface(s).
Press <Ctrl+Z> to end message input and press <Ctrl+C> to remove this operation
when inputting messages.
Example # Send the message hello abc to the Console user interface.
<Sysname> send console 0
Enter message, end with CTRL+Z or Enter; abort with CTRL+C:
hello abc^Z
Send message? [Y/N]y
<Sysname>
***
***
***Message from con0 to con0
***
hello abc
<Sysname>
set authentication password
Syntax set authentication password { cipher | simple } password
undo set authentication password
View User interface view
Parameter cipher: Cipher text password.
simple: Plain text password.
password: A case sensitive string. If the password format is set to simple, the
password argument must be in plain text. If it is set to cipher, password can be
either in cipher text or in plain text depending on what has been input. A plain
text password can be a string of no more than 16 consecutive characters,