Filter
Top Products
1602 CHAPTER 96: MPLS TE CONFIGURATION COMMANDS
display tunnel-info
Syntax display tunnel-info { tunnel-id | all | statistics }
View Any view
Parameter tunnel-id: Specifies a tunnel ID, in the range 1 to FFFFFFFE. If a tunnel is specified,
only information about this tunnel will be displayed.
all: Display information about all tunnels.
statistics: Displays statistics about tunnels.
Description Use the
display tunnel-info command to display information about tunnels.
Example # Display information about all tunnels.
<Sysname> display tunnel-info all
Tunnel ID Type Destination
------------------------------------------------------
0x1100002 lsp 2.2.2.2
# Display statistics about tunnels.
<Sysname> display tunnel-info statistics
Tunnel Allocation Method : GLOBAL
Avail Tunnel ID Value : 262144
Total Tunnel ID Allocated : 1
LSP : 1
GRE : 0
CRLSP : 0
LOCAL IFNET : 0
MPLS LOCAL IFNET : 0
Type Approach to automatic route advertisement: IGP shortcut or
forwarding adjacency
Neighbor ID Remote neighbor ID
Cost Cost
State State: up or down
Neighbor Ip Address Neighbor IP address
Cost Type Cost type
Hold time Hold time
Table 419 Description on the fields of the display ospf traffic-adjustment command
Field Description
Table 420 Description on the fields of the display tunnel-info statistics command
Field Description
Tunnel Allocation Method The way that tunnels are allocated
Avail Tunnel ID Value Available tunnel IDs. Available tunnel ID values vary by
device.
Total Tunnel ID Allocated Total number of tunnel IDs that have been allocated