Filter
Top Products
908 CHAPTER 70: TERMINAL ACCESS CONFIGURATION COMMANDS
menu hotkey
Syntax menu hotkey ascii-code&<1-3>
undo menu hotkey
View Terminal template view
Parameters ascii-code&<1-3>: ASCII value of hotkey, ranging 1 to 255. “&<1-3>” means that
you can provide up to three hotkey ASCII values.
Description Use the
menu hotkey command to configure the menu hotkey.
Use the undo menu hotkey command to cancel the menu hotkey configured.
By default, no menu hotkey is configured.
If the current terminal operates on the service interface, you can switch to the
menu interface by entering the menu hotkey configured.
RTC terminal access does not support the menu function.
Note:
■ The ASCII value of the hotkey must be different from that of any other hotkey
configured on the device. Otherwise, hotkey conflicts will occur. For example,
the hotkey value cannot be set to 17 or 19 because these two values are used
for the hotkeys of flow control.
■ Using the hotkey may not get a response rapidly when the terminal displays
too much data.
■ Before using this command, make sure you enable the router to print
characters to the terminal and enable menu printing.
Related command: print information and print menu.
Example # Configure the hotkey for switching to the menu as <Alt+A>, whose
corresponding ASCII codes are a combination of 1, 96, and 13.
<Sysname> system-view
[Sysname] rta template abc
[Sysname-rta-template-abc] menu hotkey 1 96 13
menu screencode
Syntax menu screencode string
undo menu screencode
View Terminal template view