Filter
Top Products
2438 CHAPTER 163: INFORMATION CENTER CONFIGURATION COMMANDS
Use the undo info-center loghost command to restore the default
configurations on a log host.
By default, output of system information to the log host is disabled. When it is
enabled, the default channel name will be loghost and the default channel
number will be 2.
Note that:
■ The info-center loghost command takes effect only after the information
center is enabled with the info-center enable command.
■ Ensure that the IP address input is correct while using the info-center loghost
command to configure the IP address for a log host. System will prompt an
invalid address if the loopback address (127.0.0.1) is input.
■ A maximum number of 4 hosts (different) can be designated as the log host.
Example # Set to output log information to a Unix station with the IP address being
1.1.1.1/16.
<Sysname> system-view
[Sysname] info-center loghost 1.1.1.1
info-center loghost source
Syntax info-center loghost source interface-type interface-number
undo info-center loghost source
View System view
Parameter interface-type interface-number: Specifies a source interface by its type and
number.
Description Use the
info-center loghost source command to configure the source
interface to output log information to the log host.
Use the
undo info-center loghost source command to remove the source
interface to output log information to the log host.
By default, no source interface is configured to output log information to the log
host, and the system selects an interface as the source interface.
Note that the info-center loghost source command takes effect only after the
information center is enabled with the info-center enable command.
Example # Configure the interface Serial 1/0 as the source interface to output log
information to the log host.
<Sysname> system-view
[Sysname] info-center loghost source serial 1/0