Filter
Top Products
1812 CHAPTER 112: PQ CONFIGURATION COMMANDS
Parameters pql-number: Priority queue list number.
Description Use the
display qos pql command to view contents of specified PQ list (PQL) or
all PQ lists.
Default items are not displayed.
Related commands: qos pq, qos pq pql.
Examples # Display PQLs.
<Sysname> display qos pql
Current PQL Configuration:
List Queue Params
------------------------------------------------------
1 Top Protocol ip less-than 1000
2 Normal Length 60
2 Bottom Length 40
3 Middle Inbound-interface Ethernet1/0
qos pq
Syntax qos pq pql pql-index
undo qos pq
View Interface view
Parameters pql: Uses the parameters defined in specified PQ list.
pql-index: PQL index, in the range 1 to 16.
Description Use the
qos pq command to apply a group of priority list to an interface.
Use the
undo qos pq command to restore the congestion management policy at
the interface to FIFO.
By default, the congestion management policy at the interfaces is FIFO.
Except for interfaces encapsulated with X.25, all physical interfaces can use PQ.
An interface can only use one group of priority lists.
This command can configure multiple classification rules for each group in the
priority list. During traffic classification, the system matches packets along the rule
list. If matching a certain rule, a packet will be classified into the priority queue
specified by this rule; or it will be put into the default priority queue.
Related commands: qos pql inbound-interface, display qos pq interface, display qos pql,
display qos policy interface.